Dac_Test_Plan

DAC_Test_Plan

Set up DAC as shown in the diagram below (mount up on a breadboard)

dac.bmp

As the DAC is not yet connected up to any of the components on the prototype board, use a power supply to provide the 3.3V into the beginning of the circuit. Make sure that once the circuit is constructed; use a voltmeter at the end of the circuit to verify that it corresponds to the following voltages, as shown in the truth table. The range of voltages expected in this circuit is between 0.6V and 5V.If the circuit does not produce voltages between this range, then chose a different set of resistors until circuit produces required voltage outputs.

Truth Table

Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-Share Alike 2.5 License.